Edwards B-KHP-8010-N5 Installation Instructions

Installation Instructions for Catalog No to your line should not exceed five To be sure the number of devices you can connect to your tele line contact your local telephone company these devices damage the telephone network the tele company will notify the owner that it may tempo disconnect service if they consider such action nec If the owner considers the disconnection unwar they have the right to bring a complaint to the telephone company may make changes in its commu facilities equipment operations or procedures such action is required If these changes render the incompatible with the telephone company facili the telephone company will provide enough written so that necessary changes can be made in order to uninterrupted service cid 20 cid 7 cid 2 cid 4 cid 6 cid 18 cid 6 cid 4 cid 13 cid 8 cid 6 cid 9 cid 10 cid 3 Mount the phone horn to a flat surface using three screws not provided Remove the four 8 X 5 8 16mm round head Phillips and remove the phone horn cover the telephone line through the weatherproof and tighten the connector Wire the phone as shown in Figure 2 Replace the phone horn cover and secure with the removed in Step 2 Plug the phone horn into a 120V AC outlet Test the phone horn by dialing the appropriate number extension cid 23 cid 24 cid 15 cid 11 cid 25 cid 26 unit is not serviceable or repairable Should the fail to operate contact the supplier for this product should fail to operate disconnect it from telephone line and determine if the problem is in the line or the device If this product is defective its use and obtain a replacement 1 Phone Horn Dimensions Edwards B KHP 8010 N5 Phone Horn is a solid state unit powered by 120V 60 Hz The unit is by AC or DC voltage through solid state relays Phone Horn is designed for use in indoor and outdoor that have medium ambient noise level such as ware construction sites garages and car lots The unit rated at 104 dB at 10 feet 3.05m The phone horn is UL and comes with strain relief weatherproof connec for securing the 6 foot 1.83m power cord and tele line to the housing devices are intended for connection to single telephone or key systems only They are not for use on party line or on coin operated lines When installed in accordance with these instructions devices can be readily disconnected without equipment remaining on the telephone with the Federal Communications in compliance with Part 68 of FCC Rules Regulations UL Listed Type NM non monitored signal device cid 15 cid 2 cid 16 cid 2 cid 7 cid 17 cid 9 cid 10 cid 2 cid 14 cid 11 cid 10 cid 18 cid 9 cid 5 cid 12 cid 13 cid 8 cid 6 cid 9 cid 10 following information may be required by the tele company Telephone Number FCC Registration 3Z9USA 21250 RG N Ringer Equivalence Number 1.5B at greater then 50 Volts and 3.4B at less than Volts REN allows the installer to determine the number of that can be added to the telephone line and still all the devices ring when the number is called In but not all areas the sum of all RENs for all devices CT 203 699 3300 FAX 203 699 3365 CUST SERV 203 699 3078 TECH SERV ISSUE 4 2001 2 Electrical Connections terminals accept 26 12 AWG wire size ISSUE 4