Fike 135 degree 190 degree Rate of Rise Thermal Detector P 1 19 01

Architect and Engineer Specification with 6 base FEATURES or 190 fixed temperature detectors employ a 12o minute rate of rise Listed spacing up to 60 by 60 or 4 wire base compatibility relay bases available stable operation RF Transient protection standby current 35 nominal built in power alarm LEDs for 360 viewing Electronic Operation LEDs confirm detector status with 63 1024 and 67 1033 and their bases Voltage Voltage Voltage Current Current Current Temperature Rating Case Material 7.5 7.5 30.0 VDC 33.0 VDC VDC 24 VDC max 24 VDC max 24 VDC to 120 to 49 Contacts max 24 V PC ABS Blend RATE OF RISE DETECTORS 60 1029 135O 60 1030 190O L Listed S4067 Approval 3010873 7270 0410 151 284 91E Vol IV 135o 190o fixed temperature rate of rise heat detectors suited for installation where high heat output fires are or in areas where ambient conditions would not use of other detection methods Heat detectors are for protection of property Do not rely on heat for life safety protection Where life safety is concern smoke detectors must also be used A UL listed alarm panel must electronically supervise the heat fixed temperature rate of rise heat detectors are suited detect in the presence of slow or fast rising temperatures to burning combustibles The construction of these incorporate a thermistor heat element protected damage by the built in durable plastic guard These heat detectors incorporate two power alarm LEDs 360 indication of status In standby condition the power flash Green In an alarm condition the LEDs latch on The electronic heat detection circuitry performs the function as a Mechanical Device but with Electronic If the heat rise is less than 12 the detector not alarm until it reaches its alarm temperature 135 190 7.5 If the heat rise is greater than 12 detector will alarm immediately giving an early warning and latching the Red alarm LEDs on 2003 Issue S 10th Street P O Box 610 cid 127 Blue Springs Missouri 64013 0610 U S A cid 127 816 229 3405 cid 127 Fax 816 229 0314 cid 127 www fike com SPECIFICATIONS heat detectors where ambient temperatures do not exceed 120 shall be the 60 1029 fixed temperature heat detector rated at 135 For areas where ambient temperatures exceed 120 but not 160 the 60 fixed temperature rate of rise heat detector rated at 190 shall be used detectors shall be installed in accordance with National Fire Protection Association Standard 72 the spacing by Underwriters Laboratories and in accordance with the rules and regulations set forth by the local authorities jurisdiction Automatic heat detectors shall be Underwriters Laboratories listed Fike Corporation All rights reserved No previously 1175 are subject change without notice