Fike Agent Release Module C 1 04 01

AGENT RELEASE MODULE Agent Release Module ARM III Fike P N 10 1832 in conjunction with a Control Panel allows the electrical actuators used with Fike Clean Agent to be wired in parallel This configuration substantially increases the reliability of the Clean Agent releasing circuit With series wired actuator a problem in a single actuator will incapacitate the entire system Utilizing actuators that same incident would incapacitate only that individual Agent container all others would still be active Agent Release Module ARM III is compatible with either Class A or Class wiring When an ARM III is used in a Class A wiring configuration the system is the most reliable available for today Fire Protection Fike Agent Release Module ARM III is mounted in the lower right corner of 4 11 16 11.9 cm square box which connects to the actuator boss on the Clean container The ARM III is a solid state circuit board and contains a terminal for the connections of field wiring and actuator leads The module is also with a polarity diode that illuminates if the field wiring has been installed reversed polarity Special care should be taken to assure proper polarity Agent Release Module AND ENGINEERING SPECIFICATIONS Clean Agent container shall be provided with a Fike P N 10 1832 Agent Module ARM III to allow all electrical actuators to be connected in Series wired actuators are not acceptable The ARM III shall be located each container and shall be securely mounted in the lower right hand corner of 4 11 16 11.9cm square electrical box with cover All wiring to the Clean container and the actuator leads shall connect to a terminal strip located on ARM III UL Listed S3217 FM Approved Cheetah 0B4A6 AY Rhino 0Y4A4 AY SHP Pro 0Z8A0 AY DIAGRAM CONTROL PANEL R B Y G 10 1832 ARM EOL R B Y G 10 1832 ARM of 6 ARMs No C 1.04.01 2 S 10th Street P O Box 610 Blue Springs Missouri 64013 0610 U S A 816 229 3405 816 229 4615 www fike com page intentionally left blank Fike Corporation All Rights Reserved No C 1.04.01 2 March 2005 Specifications are subject to change without notice