DSC PC5108_v2_0_IS_EN_NA

Installation Instructions PC5108 module can be used to add up to 8 additional hardwired to the PC5010, PC5015 & PC5020 control panels (see the control Installation Manual for complete installation instructions). Module Current Draw: 35 mA Auxiliary Current: 100 mA (PTC protected – fuseless design) Description Warranty Warranty Warranty Digital Security Controls Ltd. warrants that for a period of twelve months from the date of Warranty Warranty the product shall be free of defects in materials and workmanship under normal use and that in of any breach of such warranty, Digital Security Controls Ltd. shall, at its option, repair or replace defective equipment upon return of the equipment to its factory. This warranty applies only to defects in and workmanship and not to damage incurred in shipping or handling, or damage due to causes the control of Digital Security Controls Ltd., such as lightning, excessive voltage, mechanical water damage, or damage arising out of abuse, alteration or improper application of the equipment. foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other whether expressed or implied, and of all other obligations or liabilities on the part of Digital Controls Ltd. This warranty contains the entire warranty. Digital Security Controls Ltd. neither nor authorizes any other person purporting to act on its behalf to modify or to change this nor to assume for it any other warranty or liability concerning this product. no event shall Digital Security Controls Ltd. be liable for any direct or indirect or consequential damages, of anticipated profits, loss of time or any other losses incurred by the buyer in connection with the installation or operation or failure of this product. Digital Security Controls Ltd. recommends that the entire system be completely tested on a basis. However, despite frequent testing, and due to, but not limited to, criminal tampering or disruption, it is possible for this product to fail to perform as expected. COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your to use this equipment. equipment generates and uses radio frequency energy and if not installed and used properly, in strict with the manufacturer instructions, may cause interference to radio and television reception. It has type tested and found to comply with the limits for Class B device in accordance with the specifications in of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference any residential installation. However, there is no guarantee that interference will not occur in a particular If this equipment does cause interference to television or radio reception, which can be determined by the equipment off and on, the user is encouraged to try to correct the interference by one or more of the measures: Re-orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits. necessary, the user should consult the dealer or an experienced radio/television technician for additional The user may find the following booklet prepared by the FCC useful: to Identify and Resolve Interference Problems This booklet is available from the U.S. Government Printing Office, D.C. 20402, Stock # 004-000-00345-4. – This can be used to tamper the cabinet in which the PC5108 is Connect a normally closed (NC) switch across TAM and BLK. If tamper is not being used connect a piece of wire across TAM and BLK remove the trouble condition. Digital Security Controls Ltd. Canada Technical Support: 1-800-387-3630 in Canada 29004817 R001 Zone Expander 2.O is a built-in tamper switch on the expander module located in top left corner of the circuit board. If the cabinet in which the Zone Expander is mounted has the hardware required to this tamper switch, DO NOT connect anything to the TAM – Used to provide power for devices. Maximum current draw is not to 100 mA. Connect the positive lead of powered devices to VAUX and