Gamewell-FCI SpectrAlert Advance Field-Selectable Mass Notification Devices

SpectrAlert Notification Devices Electrically compatible with legacy SpectrAlert products Automatic selection of 12 or 24 volt operation at 15 and candela Field selectable candela settings of 15 15 75 30 75 110 115 135 150 177 185 refer to Candela De Table for equivalent candela ratings for UL 1971 Rated for 32 to 120 0 to 49 Plain weatherproof devices are NEMA 4X IP56 K des in part number Plug in design Tamper resistant construction with Torx head mounting Shorting spring on mounting plate for continuity check device installation Design minimizes device intrusion into the back box Housing can be either wall or ceiling mounted White plastic housings available with ALERT clearly vis in red letters Amber lens strobes and speaker strobes available Color lens attachments are easily used with any non fire or ceiling strobe Compatible with System Sensor synchronization ISO 9000 2000 Company Sensor SpectrAlert Advance offers a variety of designed for mass notification including plain for non fire applications amber lens strobes and strobes alert printed devices and color lens Sensor SpectrAlert Advance offers a wide range of notification devices including plain non fire printed amber lens strobes and speaker strobes alert devices and color lens strobe devices The SW SWH ALERT and SPSW ALERT strobes and strobes are designed with an amber colored lens in a white housing to allow visual signaling for notification in compliance with ANSI UL1638 Stan for General Signaling Visible Appliances SW ALERT SWH ALERT and SPSW ALERT amber strobes and speaker strobes provide simple installa and instant compatibility with SpectrAlert Advance syn systems Additional ALERT models are available clear lenses that can be used with color lens strobe to meet requirements for a range of mass noti applications Furthermore SpectrAlert Advance a wide variety of non fire printed devices includ indoor and outdoor strobes horn strobes and speaker part of the SpectrAlert Advance line all System Sensor notification devices include to increase product versatility and save time and For example a plug in design simplifies installation reduces ground faults a shorting spring on the mount plate tests wiring continuity to speed installation and devices from damage and field selectable settings installers to quickly set each device to meet applica requirements is a trademark and SpectrAlert and System Sensor are registered trade of Honeywell International Inc by ADT All rights reserved Unauthorized use this document is strictly prohibited are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1653 USA Tel 203 484 7161 Fax 203 484 7118 Honeywell International Inc All rights reserved Rev A page 1 of 5 Advance SW ALERT and Amber Lens Strobe Specifications Specifications Advance strobes and horn strobes shall mount a standard 4 x 4 x 11 2 inch back box 4 inch octagon box or double gang back box Two wire products also mount to a single gang 2 x 4 x 17.8 inch back SpectrAlert Advance speaker strobes shall mount to a x 4 x 21 8 inch back box A universal mounting plate be used for mounting ceiling and wall products notification appliance circuit wiring and amplifier wiring terminate at the universal mounting plate Also Spec Advance products when used with the Sync Cir Module accessory shall be powered from a non notification appliance circuit output and shall oper on a nominal 12 or 24 volts When used with the Module 12 volt rated notification appliance outputs shall operate between 9 and 17.5 volts 24 notification appliance circuit outputs shall oper between 17 and 33 volts Indoor SpectrAlert Advance shall operate between 32 and 120 degrees Fahr from a regulated DC or full wave rectified unfiltered supply Strobes horn strobes and speaker strobes have field selectable candela settings including 15 30 75 95 110 115 135 150 177 and 185 strobe shall be a System Sensor SpectrAlert Advance Listed to UL 1971 clear lens strobes and be approved for fire protective service or shall be for fire protective service as listed in ANSI UL amber lens strobes The strobe shall be wired as a notification appliance and comply with Americans with Disabilities Act requirements for visible appliances flashing at1 Hz over the strobe operating voltage range The strobe light shall con of a xenon flash tube and associated lens reflector Strobe Combination horn strobe shall be a System Sensor SpectrAlert Model Listed to UL 1971 and UL 464 and be approved for fire protective service horn strobe shall be wired as a primary signaling noti appliance and comply with the Americans with Dis Act requirements for visible signaling appliances at 1 Hz over the strobe entire operating voltage strobe light shall consist of a xenon flash tube and lens reflector system The horn shall have audibility options and an option to switch between a three pattern and a non temporal continuous These options shall be set by a multiple position The horn and horn strobe models shall operate on coded or non coded power supply Strobe Combination speaker strobe shall be a System Sensor SpectrAlert Model Listed to UL1480 and UL and be approved for fire protective signaling sys Speaker shall be capable of operating at 25.0 or nominal Vrms selected via rotary switch and shall a frequency range of 400 to 4000 Hz Speaker shall power taps that are selected by rotary switch The shall comply with the NFPA 72 requirements for vis signaling appliances flashing at 1 Hz over the strobe operating voltage range The strobe light shall con of a xenon flash tube and associated lens reflector Products Advance outdoor strobes horn strobes and strobes shall be listed for outdoor use by UL and operate between minus 40 degrees and 151 degrees The products shall be listed for use with a Sys Sensor outdoor weatherproof back box with half inch three fourths inch conduit entries Module module shall be a System Sensor Sync Circuit model listed to UL 464 and shall be approved for fire protec service The module shall synchronize SpectrAlert at 1 Hz and horns at temporal three Also while the strobes the module shall silence the horns horn strobe models over a single pair of wires The shall mount to a 411.16 x 411.16 x 21.8 inch back The module shall also control two Style Y class B or one Style Z class A circuit The module shall multiple zones Daisy chaining two or more modules together will synchronize all the they control The module shall not operate on a power supply Lens Strobe Attachment System Sensor SpectrAlert Advance color lens attach shall be approved for fire protective service as listed UL 1638 The lens attachments shall only be used with printed System Sensor strobe devices They shall to any wall or ceiling strobe and be rated from 35 degrees to 151 degrees Fahrenheit Specifications Operating Series Operating Range to 120 to 151 to 93 non condensing models Wall Mount Strobe and Horn Strobe including lens 5.6 L x 4.7 W x 2.5 D SPS Speaker Strobe including lens and speaker L x 11.9 W x 6.35D cm L x 5.0 W x 4.7 D L x 12.7 W x 11.9 cm Rev A page 2 of 5 Clintonville Road Northford CT 06472 1653 USA Tel 203 484 7161 Fax 203 484 7118