Gamewell-FCI SpectrAlert Advance P PC, S SC & H Series Horn Strobes

SpectrAlert Output Appliances Ceiling Horn Strobe Ceiling Strobe Wall Horn Strobe Ceiling Strobe Wall Horn Wall Strobe Provides a plug in design Comprises an assortment of outdoor wall and ceiling Has tamper resistance capability with minimal intrusion into backbox Offers the same mounting plate for wall and ceiling mount a shorting spring on the mounting plate for a check before installation and a captive mounting Field selectable candela settings on wall or ceiling units 15 75 30 75 95 110 115 135 150 177 185 Contains an automatic selection of 12 or 24 volt operation at Outdoor products rated from and 151 and 15 75 candela and 66 Horn rated at 88 dbA at 16 volts Provides a rotary switch for tone selection Offers three horn volume settings Electrically compatible with SpectrAlert products 7125 1653 0188 Advance selectable output horns strobes horn strobes are rich with features guaranteed to installation times and maximize profits The Advance Series of notification appliances is to simplify your installations that offer the features Plug in designs feedback messages to ensure correct installa of individual devices Eleven field selectable candela settings for wall ceiling and horn strobes specifically to install the Advance products do the Attach a universal mounting plate to a four inch four inch octagon or double gang junction two wire mounting plate attaches to a single gang box Connect the notification appliance circuit wiring to the terminals on the mounting plate To attach the horn strobe or horn strobe to the plate insert the product tabs in the mount plate grooves Rotate the device into position locking the product into the mounting plate terminals The device temporarily holds in place with a catch you secure it with a captured mounting screw Advance products offer the options 12 or 24 volts At 24 volts 15 15 75 30 75 95 110 115 135 150 or 185 candela by way of rear mounted slide and front viewing window Horn tones and volume by way of rotary switch SpectrAlert Advance series includes outdoor notifica appliances Outdoor strobes and horn strobes two and four wire are available for wall or ceiling Outdoor are available for wall only All System Sensor out products are rated between and 151 66 in wet or dry applications is a trademark and SpectrAlert and System Sensor are registered trade of Honeywell International Inc by ADT All rights reserved Unauthorized use this document is strictly prohibited GAMEWELL FCI are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Clintonville Road Northford CT 06472 1653 USA Tel 203 484 7161 Fax 203 484 7118 Honeywell International Inc All rights reserved www gamewell fci com Rev D page 1 of 4 Models wall mount horn strobe 2 wire horn strobe horn strobe ceiling mount strobe 2 wire horn strobe horn strobe Outdoor wall mount horn strobe 2 wire horn strobe Outdoor ceiling mount strobe 2 wire horn strobe horn strobe horn strobe Specifications Advance horns strobes and horn strobes shall on a standard 4.0 x 4.0 x 1.5 10.16 x 10.16 x cm backbox 4.0 10.16 cm octagonal backbox or a backbox Two wire products shall also mount a single gang 2.0 x 4.0 x 1.875 5.08 x 10.16 x 4.763 backbox A universal mounting plate shall be used for ceiling and wall products The notification appli circuit wiring shall terminate at the universal mount plate Also SpectrAlert Advance products when used the Sync Module accessory shall be pow from a non coded notification appliance circuit output shall operate on a nominal 12 or 24 volts When used the Sync Module 12 volt rated notification circuit outputs shall operate between 9 and 17.5 24 volt rated notification appliance circuit outputs operate between 17 and 33 volts Indoor SpectrAlert products shall operate between 32 and 120 and 49 from a regulated DC or full wave rectified power supply Strobes and horn strobes shall field selectable candela settings including 15 15 75 75 95 110 115 135 150 177 185 strobe shall be a System Sensor SpectrAlert Advance Listed to UL STD 1971 and shall be for fire protective service The strobe shall be as a primary signaling notification appliance and with the Americans with Disabilities Act require for visible signaling appliances flashing at 1 Hz over strobe entire operating voltage range The strobe shall consist of a xenon flash tube and associated system Combination horn strobe shall be a System Sensor SpectrAlert Model Listed to UL Standards 1971 and and shall be approved for fire protective service The shall be wired as a primary signaling notifica appliance and comply with the Americans with Disabil Act requirements for visible signaling appliances at 1 Hz over the strobe entire operating voltage The strobe light shall consist of a xenon flash tube associated lens reflector system The horn shall have audibility options and an option to switch between a 3 pattern and a Non Temporal continuous pat These options are set by a multiple position switch four wire products the strobe shall be powered inde of the sounder The horn on horn strobe models operate on a coded or non coded power supply Products Advance outdoor horns strobes and horn shall be listed for outdoor use by UL and shall between and 151 and 66 The shall be listed for use with a System Sensor out backbox with half inch and three conduit entries Module module shall be a System Sensor Sync Listed to UL STD 464 and shall be approved for protective service The module shall synchronize strobes at 1 Hz and horns at Temporal 3 Also operating the strobes the module shall silence the on horn strobe models over a single pair of wires module shall mount to a 4.688 x 4.688 x 2.125 x 11.906 x 5.398 cm backbox The module shall control two Style Y Class B circuits or one Style Z A circuit The module shall synchronize multiple Daisy chaining two or more synchronization mod together will synchronize all the zones the modules The module shall not operate on a coded power Specifications operating Series operating F to 120 F 0 C to 49 C range flash rate voltage voltage terminal wire lens lens dimensions F and 151 F C and 66 C to 93 non condensing products flash per second 12 VDC FWR or regulated VDC FWR Full Wave Rectified FWR is a non regulated time power source that is used some power supply and panel V to 17.5 V 12 V nominal or 16 to 33 V 24 V nominal P S PC and SC products will at 12 V nominal only for 15 and 15 75 cd to 18 AWG 3.31 to 0.821 mm2 diameter x 2.5 deep diameter x 6.4 deep cm H x 4.7 W x 2.5 D H x 11.9 W x 6.4 D cm H x 4.7 W x 1.3 D H x