Hochiki FN-DAC Quick-Start Guide 2

FireNET FN DAC Quick Start Guide guide is designed to explain the basic steps necessary to install and use the FN DAC Please consult the FN DAC Installation and Operation Manual part number for complete instructions on the installation and operation of the FN DAC You must use panel firmware 3.800 or greater You must use Loop Explorer software version 6.0 or greater you have questions about the firmware and software required to use the FN DAC please Hochiki America before proceeding Remove power from the panel before installing the FN DAC 1 Using the four mounting screws install the FN DAC in the enclosure 2 Connect 24 VDC power to the J7 connector Be sure to observe correct polarity 3 Connect the ribbon cable between the J2 connector and the FireNET panel J5 PC 4 Connect the telephone lines to the FN DAC L1 and L2 are the incoming phone lines and P2 are used to connect the premise phones RJ31X jacks must be used pages 11 22 of the FN DAC Installation and Operation Manual for additional details 1 of 2 1 You must add the FN DAC from the level 3 menu Edit Configuration Edit I O Add 2 Program the correct account number reporting format protocol and phone number the menu options Edit Configuration Edit I O Edit Dialer Edit Accounts Attributes 1 is the primary account and account 2 is the backup account Both accounts must be Accounts 3 and 4 are for optional duplicate reporting the up and down arrow keys to make your programming selection Use the right arrow key move to the next location press the Enter button when programming is complete may also use Loop Explorer to configure the FN DAC Please see pages 28 37 of the manual for additional details on programming Section 5 of the FN DAC manual Testing should be done by generating reportable events the FireNET panel Confirm receipt of the events with your monitoring station Section 5 of the FN DAC manual Quick Start Guide Feb 2008 revision 0.1 2 of 2