Mircom CAT-5954 MS-710APU (English)

ADVANCED PROTOCOL INTELLIGENT MANUAL STATION Dual Action Key resettable Permanently attached Intelligent Addressable Module Rotary switches for direct dial entry of address Each unit have address set for 01 159 for Advanced Protocol and 01 99 for CLIP mode High gloss red enamel finish Plastic breakrod Meets ADA 5 lb maximum manual force Mounts on standard single gang box Mircom BB 700 metal backbox or BB 700WP weather proof MS 710APU Dual Action Intelligent Manual Station is by pushing the bar labelled BAR and then down the handle marked HANDLE The MS is reset by opening the station with the key placing the in the normal upright position and re locking the station manual station shall be Mircom MS 710APU Operating shall be in raised English lettering and the unit shall constructed of high quality die cast metal and finished in red paint to provide quick identification Pulling the handle initiate immediate operation of the intelligent addressable All manual fire alarm stations shall be installed as per specific requirements outlined in the UL codes as well as other applicable national or local codes Final acceptance subject to the local authority having jurisdiction MS 710APU Advanced Protocol Intelligent Manual is made of a high quality die cast metal and is available a dual action device with key resets and a permanently intelligent module The intelligent manual station a pair of rotary decimal switches which allows for two digit setting Pulling the handle initiates the operation of intelligent module manual station is available with CAT 30 keys and mounts a standard single gang backbox Mircom model BB 700 surface metal backbox or BB 700WP weather proof Advanced Protocol AP devices use a high speed protocol that greatly increases the speed of between the intelligent devices Mircom Protocol uses a superior group polling method as as an interrupt feature that provide for a faster response to alarm condition In addition the Advanced Protocol allows greater system capacity with support for up to 318 devices SLC circuit The AP devices are backwards compatible to in CLIP mode for legacy system applications TO BE USED FOR INSTALLATION PURPOSES INFORMATION IS FOR MARKETING PURPOSES ONLY AND INTENDED TO DESCRIBE THE PRODUCTS TECHNICALLY NUMBER Operating Voltage Alarm Current 24V Operating Current 24V Mount Backboxes H x 3.56 W x 2.9 D VDC Surface Mount H x 3.6 W x 2.0 D Weatherproof Mount Backbox H x 3.6 W x 2.2 D Diagram NEXT STATION OR OF LINE DEVICE Diagram OF MANUAL STATION HOLE STATION GANG BOX BLACK RED HOLE Information Protocol Intelligent Key Resettable Dual Action Manual Station 700 Interior Surface Mount Backbox Red Finish 700 Weatherproof Surface Mount Backbox Red Finish indicator plastic break bar Interchange Way Vaughan ON L4K 5W3 905 660 4655 Fax 905 660 4113 Witmer Industrial Estates Niagara Falls NY 14305 Free 888 660 4655 Fax Toll Free 888 660 4113 INFORMATION IS FOR MARKETING PURPOSES ONLY AND INTENDED TO DESCRIBE THE PRODUCTS TECHNICALLY complete and accurate technical information relating to performance installation testing certification refer to technical literature This document contains intellectual property of The information is subject to change by Mircom without notice Mircom does not or warrant correctness or completeness All rights reserved All other trademarks registered trademarks are properties of their respective owners 5954 1