Notifier MPS-950B Series Non-Coded Manual Fire Alarm Pull Stations

MPS 950B Series Manual Fire Alarm Stations MPS 950B Series Pull Stations provide manual reporting The MPS 950B Series manual stations are normally open contacts manual initiating alarm stations ULC Listed Durable extruded aluminum construction Attractive low profile design Standard single gang mounting Easy identification Converts to double action with optional kit MPS DALK Two stage option Key switch available MPS 950 Series Pull Stations are constructed of curable aluminum and finished in red baked enamel An resistant label with large raised letters provide legible bilingual instructions to facilitate identification operation rectangular low profile design blends with modern archi decor The manual pull stations consist of a pull door and its support both made of extruded aluminum are designed for semi flush mounting on a single gang MPS 950 pull stations can be easily converted from sin double action kit double action with addition of station mounts with two screws supplied to a standard electrical box It can also be mounted to a sur box NBS 950 The terminal block with screws allows quick and easy connections on the station handle will release the internal switch trigger the alarm detection circuit is accomplished by inserting a 1 8 screwdriver the front The handle once pulled will remain open and be reset without using a screwdriver MPS 950KB and the MPS 950KB 20C two stage ver also provide a key switch which is accessible after the has been pulled Operation of the key switch when to a separate general alarm circuit will initiate the stage of a two stage alarm signaling system A spe key is supplied with each unit MPS Series of pull stations are also available with addi N C contacts This optional contact will operate when handle has been pulled DN 60910 A Initiating Devices 4.5 11.43 cm 3.5 8.9 cm 0.75 1.9 cm rating all models A 30 VDC 0.1 A 125 VAC to 2 x 4 x 2.25 outlet box Information Single Stage Pull Station Two Stage Pull Station with keyswitch Single Stage Pull Station with additional contact Two Stage Pull Station with additional contact keyswitch Double Action Lever Kit converts any of the Surface mount box Break Glass Rods for MPS 950B Series of 10 Listings S6919 DN 60910 A 6 6 2016 Page 1 of 2 Surface Backbox Double Lever Kit cm cm cm 2.06 cm cm cm Diagrams next or next station EOL or only switch for keyswitch for MPS 950KB MPS 950KB 20C Break Glass Rod GL 004K switch for next station EOL switch switch as shown so that supervision of connections is maintained is a registered trademark of Honeywell International Inc by Honeywell International Inc All rights reserved Unauthorized use this document is strictly prohibited document is not intended to be used for purposes We try to keep our information up to date and accurate cannot cover all specific applications or all requirements All specifications are to change without notice more information contact Notifier 289 1114 Whitmore Road Ontario LZL 7Z4 Page 2 of 2 Canadian DN 60910 A 6 6 2016