Notifier Phone Storage Box Installation Guide

File Preview
File Preview
Click below to download for free

File Data

Name notifier-phone-storage-box-installation-guide-3085742961.pdf
Type PDF
Size 1.08 MB

Text Preview

One Fire Place CT 06472 203 484 7161 203 484 7118 PK LCD 80 Manual NOTIFIER Alarm Control Panels SET STEP Acknowledge FOR TEST 15658 Revision A ECN 99 395 of Fire Alarm Systems installing a fire alarm system may make lower insurance possible it is not a substitute for fire insurance automatic fire alarm system typically made up of smoke de heat detectors manual stations audible warning de and a fire alarm control remote notification capability provide early warning of a fire Such a system does not assure protec against property damage or of life resulting from a fire Manufacturer recommends smoke and or heat detectors located throughout a protected following the recommen of the current edition of National Fire Protection Asso Standard 72 NFPA 72 recommenda State and local codes and recommendations contained the Guide for Proper Use of Smoke Detectors which made available at no charge to installing dealers A study by Federal Emergency Manage Agency an agency of the States government indi that smoke detectors may go off in as many as 35 of fires While fire alarm systems designed to provide early against fire they do not warning or protection fire A fire alarm system not provide timely or adequate or simply may not func for a variety of reasons detectors may not sense where smoke cannot reach detectors such as in chim in or behind walls on roofs on the other side of closed Smoke detectors also not sense a fire on another or floor of a building A sec floor detector for example not sense a first floor or fire of combustion or from a developing fire not reach the sensing cham of smoke detectors because Barriers such as closed or par closed doors walls or may inhibit particle smoke flow Smoke particles may become stratify and not reach ceiling or upper walls detectors are located Smoke particles may be blown from detectors by air out Smoke detectors may be into air returns before the detector amount of smoke present be insufficient to alarm detectors Smoke detec are designed to alarm at vari levels of smoke density If density levels are not cre by a developing fire at the of detectors the detec will not go into alarm detectors even when properly have sensing Detectors that have sensing cham tend to detect smoldering better than flaming fires have little visible smoke that have ionizing type chambers tend to detect flaming fires betters than fires Because fires in different ways and are unpredictable in their neither type of detector is best and a given type detector may not provide ad warning of a fire detectors cannot be ex to provide adequate warn of fires caused by arson chil playing with matches espe in bedrooms smoking in and violent explosions by escaping gas im storage of flammable ma etc detectors do not sense par of combustion and alarm when heat on their sensors at a predetermined rate reaches a predetermined level heat detectors may subject to reduced sensitivity time For this reason the feature of each detec should be tested at least once year by a qualified fire protec specialist Heat detectors designed to protect property life Smoke detectors be installed in the same as the control panel and in used by the system for the of alarm transmission communications signaling power If detectors are so located a developing fire damage the alarm system its ability to report a fire warning devices such bells may not alert people if devices are located on the side of closed or partly doors or are located on an floor of a building Any device may fail to alert with a disability or those have recently consumed alcohol or medication note that Strobes can under certain cir cause seizures in with conditions such as Studies have shown that cer people even when they a fire alarm signal do not or comprehend the of the signal It is the owner responsibility conduct fire drills and other exercise to make aware of fire alarm sig and instruct them on the reaction to alarm sig rare instances the sounding a warning device can cause or permanent hear loss fire alarm system will not oper without any electrical power AC power fails the system will from standby batteries for a specified time and only the batteries have been prop maintained and replaced used in the system not be technically compatible the control It is essential to only equipment listed for ser with your control panel lines needed to alarm signals from a to a central monitoring may be out of service or disabled For added against telephone line backup radio transmission are recommended most common cause of fire malfunction is inadequate To keep the entire Publications PRECAUSM P65 p1 11 10 99 alarm system in excellent order ongoing mainte is required per the recommendations UL and NFPA standards At minimum the requirements of 7 of NFPA 72 shall be Environments with amounts of dust dirt or high velocity require more frequent A maintenance should be arranged the local manufacturer Maintenance be scheduled monthly or required by National and or fire codes and should be by authorized profes fire alarm installers only written records of all should be kept Warning This equipment uses and can radi radio frequency energy if not installed and used in with the instruc manual may cause inter to radio communica It has been tested and to comply with the limits class A computing device to Subpart B of Part of FCC Rules which is to provide reason protection against such when operated in commercial environment of this equipment in residential area is likely to interference in which the user will be required correct the interference at own expense Requirements digital apparatus does exceed the Class A limits radiation noise emissions digital apparatus set out the Radio Interference Reg of the Canadian De of Communications present appareil numerique pas de bruits radio depassant les applicables aux numeriques de la A prescrites dans le sur le brouillage edicte par le des Communica du Canada Precautions to the following will aid in installation with long term reliability Several different of power can be con to the fire alarm control Disconnect all sources of before servicing Control and associated equipment be damaged by removing inserting cards modules interconnecting cables while unit is energized Do not at to install service or oper this unit until this manual is and understood System Reaccep Test after Software To ensure proper sys operation this product must tested in accordance with 72 1996 Chapter 7 after programming operation or in site specific software testing is required any change addition or de of system components or any modification repair or to system hardware wiring components circuits system or software functions to be affected by a change be 100 tested In addi to ensure that other opera are not inadvertently af at least 10 of initiating that are not directly af by the change up to a of 50 devices must be tested and proper system verified system meets NFPA re for operation at 0 49 F and at a relative of 85 RH non con at 30 C 86 F How

Related Files