Cerberus Pyrotronics LED-3 Remote Annunicators 7903

LED Series Annunciators for SXL and PXL AND ARCHITECT SPECIFICATIONS LED 3 and LED 4 8 Zone LED Display Annunciates Zone Alarms Supervisory Trouble Conditions Surface or Semi flush Installation 4 Wire Connection to SXL Supervised PXL Field Programmable 2 Remote Annunciators per SXL or PXL ULC Listed CSFM NYMEA FM Approved Pyrotronics Remote LED Annunciators are to be used with the SXL or PXL Fire Alarm Panels They are eight point annunciators contain sixteen LED for the display of alarm supervisory or conditions by zone LED can be located in the building lobby or in a area In its quiescent mode of operation all are off In the event of an alarm a red LED will light to which device or zone is in alarm To report troubles removal of a detector head the corresponding yellow will light Supervisory conditions are annunciated by corresponding amber zone LED The left most LED is a device which illuminates red for zone alarm condi and amber for supervisory zones The Remote Annun may be tested by using the Lamp Test feature in the or PXL test mode perform the important service of pinpointing location of the alarm device or the zone from which an originates and Architect LED annunciators will have LED for Alarm and Trouble conditions per zone There will be zones per annunciator It shall be connected to the or PXL auxiliary port The annunciator shall be addres via DIP switches The remote annunciator shall be Pyrotronics model LED 3 LED 4 actuation of an initiating zone the corresponding LED will light red Each additional zone will light its corresponding LED a supervisory circuit changes state to off normal the LED will light amber When an initiating goes into trouble the yellow zone trouble LED will The Remote Annunciator can be tested using the Test feature of the Control Panel to indicate proper of the LEDs NUMBER Information No No Remote Annunciator Black Remote Annunciator White annunciators are field programmable at the time of The dipswitch address must be set and the configured for use of the LED via the program mode the control panel Please see the Installation Instructions 315 093066 for further information on programming and and Environmental Power Current VDC Alarm LEDs only All LEDs lit to 49 non condensing H x 35 8 W x 11 16 D oz gang electrical box Temperature Humidity Diagram The use of other than Cerberus Pyrotronics detectors and bases with Cerberus control equipment will be considered a misapplication of Cerberus Pyrotronics and as such void all warranties either expressed or implied with regards to loss liabilities and or service problems Pyrotronics Ridgedale Ave Knolls NJ 07927 201 267 1300 201 397 7008 in U S A Pyrotronics East Pearce Street Hill Ontario 1B7 CN 905 764 8384 905 731 9182 1997 sheet date 4