Siemens FHA2043-U1 FHA2043-R1 Trim Kit for Model FHB2005-U1 R1 Backboxes, Installation Instructions

INSTALLATION INSTRUCTIONS FHA2043 Kit for Model FHB2005 U1 R1 Backboxes Model FHA2043 U1 R1 trim kits from Siemens Industry Inc are used in the Desigo FV2025 2050 and PRO FV922 924 systems to complete the semi flush mounting of the FHB2005 U1 R1 backboxes The FHA2043 U1 R1 trim kit is designed for indoor use only in dry protected environments The or extension to the Desigo PRO part numbers identifies the paint color and sales through which the part is marketed A in the extension designates that the part is painted an designates that the part is painted red to meet local code requirements The numeral following the color designation identifies the sales channels for the part as follows channels 1 2 Desigo 3 Cerberus PRO For semi flush mounted backboxes all electrical wiring is run in the wall illustrated in Figure 1 the FHA2043 U1 R1 trim kit is mounted on the outside of the backbox and secured place using 6 32 x screws provided with the kit 4 PLACES BACKBOX INDICATED BY ARROWS PLACES x 3 8 SCREW INTO DIMPLE 1 Trim Kit Installation Industry Inc Technologies Division Park NJ refer to Siemens Industry Inc Building Technology Division document number A6V10359788 titled Instructions for the Model FHB2005 U1 R1 3HU Black Red Backbox for the backbox installation The backbox and trim kit must be installed and secured in place before any electronic equipment installed in the backbox Please refer to Figure 1 Drilling inward from outside the backbox drill ten 3 16 diameter holes the backbox top bottom and each side at the dimples indicated by the arrows in Figure 1 holes holes holes each side Using the 6 32 x screws provided fasten each trim piece to the backbox so that the screw are on the inside of the backbox as illustrated in Figure 1 After the trim kit has been fastened to the backbox install the backbox and trim kit assembly into the hole in the wall using the procedures provided in Siemens document A6V10359788 When assembly has been mounted the backbox trim will be surface mounted on the wall FHB2043 U1 and FHB2043 R1 trim kits can be used with the FHB2005 U1 and FHB2005 R1 only WITH PART 10 6 32 x round head screws dimensions pieces 24 L x 1 H x top and bottom pieces 42 L x 1 H x left and right Industry Inc Technologies Division Park NJ Canada Limited Technologies Division Kenview Boulevard Ontario L6T 5E4 Canada ID A6V10370379 en a A5Q00058008