Siemens MKB-4 Annunciator Keypad Module, Installation Instructions

specific menu driven operations as well as and maintenance functions series of switches located on the MKB 4 the user access to the MXL IQ MXL menu There are also System status LEDs The ALARM and TROUBLE function even if the main processor fails Figure 1 JAN 01 2001 BUILDING TECHNOLOGIES Instructions MKB 4 Module Model MKB 4 Annunciator Keypad from Industry Inc provides the MXL IQ MXL with its primary control and annunciation MKB 4 communicates with the SMB or the Main Control Board through the System link MKB 4 has an 80 character backlit LCD display that continuously updates about the System status and user device messages See Figure 1 If there multiple alarms security conditions and or troubles the MKB 4 displays highest priority event that occurred The user see additional event data by pressing the key Press the HOLD key at any time to the display from scrolling are switches for the following functions Acknowledging fire alarms ALARM ACK Silencing audibles AUD SIL Acknowledging supervisories SUPV ACK Acknowledging troubles TRBL ACK Acknowledging security conditions SEC ACK is also a separate key for resetting the Panel RESET 10 digit numeric keypad allows entry of the levels of user passwords It also does 1 Panel Industry Inc Technologies Division Park NJ 315 093575 7 Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada all system power before first battery and then AC power up connect the AC first then the battery the MKB 4 Inspect the module for such as integrated circuits ICs not firmly in their sockets bent IC pins connectors properly installed dirt and packing material the board the Network Address Figure 2 Before installing the MKB 4 panel set its address on S1 the switch on the board located on the back of the Use dipswitches SW1 and SW2 on S1 to set the network address of the Refer to Table 1 for switch settings The MKB 4 module address is always set network addresses 248 through 251 One supervised MKB 4 must be installed network address 251 Other supervised may be at the other addresses 1 SETTINGS ON THE ANN 1 SETTINGS FOR Setting Supervision Switches S1 SW3 and S1 SW4 are for use Switch S1 SW5 is used to supervision 2 S1 on the ANN 1 Board Supervision switch S1 SW5 on the ANN 1 to select or supervision If your ANN 1 has a switch position 1 indicated on the left hand side the printing on the switch SW1 on S1 is the extreme right hand side of S1 regardless any other marking set for supervision Closed ON set for non supervision Open OFF When you select non supervision for an there must also be one only one supervised annunciator at same address The supervisory is independent of the network the MKB 4 to Figures 3 and 4 mount the MKB 4 in an MSE 3 3L enclosure 3 screws in the first group of 3 tapped in the right flange as shown in Figure 3 a 1 8 inch gap between the head of screw and the flange Slide the slots of MKB 4 panel hinge under the head of the and tighten After the MKB 4 is mounted to the enclosure the cable P N 555 192238 P1 on the ANN 1 on the back of the and P8 on the SMB 1 2 Be sure the black tracer wire on edge of the cable is close to 1 on position 1 of connector on the ANN 1 and the 1 on 1 of P8 on the SMB 1 2 mount the MKB 4 in an EBX 1 2 backbox the XEA 1 2 adapter plates and in the EBX 1 2 backbox according the XEA 1 2 Installation Instructions P N Mount the MKB 4 on the right bracket using hardware supplied with this module as in Figure 4 Install 3 screws in the 3 holes in the right flange Leave a 1 8 gap between the head of the screw and flange Slide the slots of the MKB 4 panel under the head of the screws Adjust position of the MKB 4 so that the module smoothly and closes securely against magnet Tighten the screws After the MKB 4 is mounted to the enclosure the cable P N 555 192238 between on the ANN 1 on the back of the MKB 4 P8 on the MMB 1 2 Be sure the black tracer wire on edge of the cable is close to 1 on position 1 of connector on the ANN 1 and the 1 on 1 of P8 on the MMB 1 2 the MKB 4 Annunciator Keyboard in the MSE 3 3L 3 EBX 1 2 BACKBOX XEA 1 2 ADAPTER PLATE MKB 4 the MKB 4 Annunciator Keyboard in the EBX 1 2 Backbox 4 RATINGS Industry Inc Building Technologies Division Park New Jersey 07932 315 093575 7 Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada