Siemens NIC-C (for FireFinder) Network Interface Card, Data Sheet

s XLS Interface Card NIC C HNET communications XNET communications CAN network communications Supports Class B Style 4 or Class A 7 wiring for XNET or HNET Supervises the HNET or XNET and CAN Diagnostic LEDs Isolates short circuit faults Ground fault detection Network repeater Downloadable firmware UL 9th Edition Listed ULC Listed FM CSFM and NYMEA Approved Overview Network Interface Card Model NIC C provides HNET or network communications between enclosures In to the HNET or XNET communication Model NIC C CAN network communication within an enclosure external to the enclosure The HNET or XNET can be Class B Style 4 or Class A Style 7 but the CAN can only be wired Class B Style 4 single Model NIC C can provide either HNET or XNET The CAN interface is available of the HNET or XNET usage Model NIC C is used for HNET communications NIC C provides communication between enclosures a single system The maximum HNET Model NIC C on a single system single node is 50 Model NIC C the HNET network to insure proper operation NIC C also isolates a short circuit fault to each segment of the HNET network Model NIC C an electrical repeater for each HNET pair Industry Inc Technologies Division NIC C View NIC C View Model NIC C is used for XNET communications NIC C provides communication between systems maximum XNET Model NIC C cards on a single system node is one 1 for a total of 59 XNET Model cards on a peer to peer networked system The XNET NIC C card must reside in the same enclosure as the Machine Interface Model PMI NIC C supervises the XNET network to ensure operation Model NIC C also isolates a short circuit to each individual segment of the XNET network NIC C provides an electrical repeater for each pair MXL systems may also reside on the same with FireFinder XLS systems FireFinder XLS will also report all events over the to the Network Command Center for display are displayed on Model NCC G Trouble Alarm Silence and System Reset are also initiated at Model NCC Model NCC also be used to perform maintenance commands on individual Fire Finder XLS on the XNET XLS 6338 continued NIC C Card takes one card slot and mounts in a or CC 5 Card cage inside a CAB 1 CAB 2 or Enclosure NIC C provides the CAN network which supports LCM 8 SCM 8 FCM 6 OCM 16 SIM 16 CAN Up to 99 CAN module addresses are per enclosure NIC C Card has diagnostic LEDs that indicate Fail CAN Fail HNET Fail XNET Fail Ground Loop A Fail and Loop B Fail as well as LEDs to Power Style and Active Networks for Ordering and Humidity Range are UL 864 9th Edition listed for indoor dry within a temperature range of 120 3 to 32 3 0 2 and at a relative of 93 2 at a temperature of 90 3 Ratings This marketing catalog sheet is not intended to be used for system design or installation purposes the most up to date information refer to each product installation instructions Industry Inc Technologies Division Safety Fernwood Road Park NJ 07932 973 593 2600 908 547 6877 www SBT Siemens com FIS in U S A Safety Kenview Boulevard Ontario 5E4 Canada 905 799 9937 905 799 9858 2010 sheet dated 7 09 2