Siemens PM-32 Program Matrix Module, Installation Instructions

Installation Instructions PM 32 Matrix Module program matrix module PM 32 is designed to offer multiple circuit activation from a variety of circuits depending on the desired functions that to be achieved upon system operation model PM 32 provides thirty six 36 individual with separate anode and cathode terminal to each diode Any combination of diode and outputs may be combined together to provide isolation or control logic required by the System 3 Panel circuitry A typical application would be the of audible devices on the fire floors floor and floor below PM 32 module occupies one standard module Modules may be double mounted two to a space where necessary Information input and output circuit is capable of carrying of up to 5 Amp 30VDC Diodes are rated at peak inverse voltage If the preceding module is on another row in enclosure a JA 24 24 in long bus connector assembly will be required Modules are to be bus connected from right to left two row enclosures the modules in the lower are to be connected from left to right Succeeding are to be alternately connected right to left left right etc a module is the last module in the system install a JS 30 30 in long or JS 64 64 in long bus assembly from the unused receptacle of last module to terminal 41 of the CP 35 control This completes the module supervision circuit Wire the circuit s as described in the CP 35 Control Instruction Manual P N 315 085063 Installation Wiring Refer to the Wiring illustration If a zone is not used the EOL device should connected to the alarm initiating circuit terminals and 3 Zone 1 or 4 and 5 Zone 2 of the module a supplementary relay module annunciator or output module is used then the alarm outputs 1 Zone 1 and 6 Zone 2 should be to these units Mount the module to the horizontal mounting in the control enclosure Test the Model JA 5 5 in long bus connector assembly between receptacle P2 of the and receptacle P1 of the module or control immediately preceding it in the bus to the CP 35 Control Panel Instruction Manual and Wiring Industry Inc Technologies Division Park NJ 315 024055 5 Building Technologies Ltd Safety Security Products Kenview Boulevard Ontario 5E4 Canada Wiring 315 024055 5 wire size 18 AWG wire size 12 AWG