Siemens PS-35 220 Power Supply Modules, Operation and Installation Instructions

Operation and Installation Instructions PS 35 220 Supply Modules Safety Model PS 35 220 stepdown transformer and bridge Siemens Building Technologies Inc provides a recti full wave 24 VDC output from an input supply of 220 50 60 Hz The input consists of a fused main power 24 volt full wave output is rated at 9 amps DC full load 6 amps DC standby load Separate output fuses are for both the main and auxiliary power outputs at 15 amps and 2 amps respectively the PS 35 220 module is used as a separate 24 VDC supply with battery backup and jumper plug JP PS 5 and 6 may provide the full 9A loading Surge is provided at the input phase as well as the DC to Connection Diagram on the left For use with the CP 35 the PS 35 220 must be in an EB Series enclosure to the right on the horizontal mounting bracket Mount the module the horizontal mounting brackets in the control Select a convenient location so that the runs are as short as possible Note that the PS occupies three module positions When using the PS 35 220 as a stand alone supply the module can be mounted on any bracket inside the enclossure Refer to P N for installation and power limited wiring Connect wiring as necessary Refer to P N 315 093680 wiring instructions protection cover plate over the terminals after wiring connections Building Technologies Ltd Kenview Boulevard Ontario L6T 5E4 CN Supply to on CP 35 1.6A max VDC 1.5A Wire Connection Power 50 60 Hz positions 1 2 4 6 are non power limited terminals If limited wiring is desired for terminals 5 and 6 use the P N 315 093495 Building Technologies Inc Fernwood Road Park New Jersey 07932 315 085628 6