Silent Knight IDPcontrol isheet

Compatibility Requirements ensure proper operation this module shall be con to a compatible Silent Knight system control pan only list available from Silent Knight IDP Control mounts directly to 4 square electri boxes see Figure 2A The box must have a mini depth of 21 8 Surface mounted electrical boxes are available All wiring must conform to applicable local ordinances and regulations When using control in nonpower limited applications UL require for the separation of power limited and nonpower terminals and wiring must be met The barrier be inserted into a 4 4 21 8 junction box and control module must be placed into the barrier and to the junction box Figure 2A The power lim wiring must be placed into the isolated quadrant of module barrier Figure 2B 1B Jumper location 1A Controls indicators OF 865 6 7 8 9 UNDER LABEL 2A Module mounting with barrier 2B to 32 VDC mA LED on AND INSTRUCTIONS Supervised Module Operating Voltage Current Draw Operating Current 390 LED flashing External Voltage on External Supply Range Terminals T3 and T4 Volts RMS or DC mA Maximum using EOL relay to 120 0 to 49 to 93 non condensing H x 4 W x 11 4 D to a 4 square by deep box Electrical Box Installing information is included as a quick reference installa guide Refer to the control panel installation manual detailed system information If the modules will be in an existing operational system inform the and local authority that the system will be tem out of service Disconnect power to the control before installing the modules This manual should be left with the owner of this equipment Description Supervised Control Modules are intended use in intelligent two wire systems where the in address of each module is selected using the rotary switches This module is used to switch an power supply to notification appliances It also the wiring to the connected loads and reports status to the panel as NORMAL OPEN or SHORT The IDP Control has two pairs of output ter points available for fault tolerant wiring and a LED indicator 3 Typical notification appliance circuit configuration NFPA Style Y MODULES TO LISTED COMPATIBLE KNIGHT CONTROL PANELS ONLY NEXT LINE CIRCUIT SLC VDC MAX PAIR RECOMMENDED WIRING SHOWN IS SUPERVISED AND POWER LIMITED PANEL OR DEVICE 8 5 6 7 8 9 1 VDC CIRCUIT NOT LOOP WIRE ON TERMINALS 4 BREAK WIRE RUN TO PROVIDE OF CONNECTIONS VDC POWER SUPPLY REGULATED POWER PER NFPA 70 FOR FIRE PROTECTION WITH BACKUP POLARITIES ARE IN ALARM EOL LISTED EOL RELAY ENERGIZED VDC COIL NEXT CONTROL MODULE OR END OF LINE RELAY RELAY REQUIRED FOR EACH CIRCUIT 4 Typical fault tolerant notification appliance circuit configuration NFPA Style Z WIRING SHOWN IS SUPERVISED POWER LIMITED LINE CIRCUIT SLC VDC MAX PAIR RECOMMENDED NEXT MODULES TO LISTED COMPATIBLE KNIGHT CONTROL PANELS ONLY PANEL OR DEVICE POLARITIES ARE IN ALARM RESISTOR IS AT 8 9 LISTED EOL RELAY ENERGIZED COIL 8 5 6 7 8 9 1 VDC CIRCUIT NOT LOOP WIRE ON TERMINALS 4 BREAK WIRE RUN TO PROVIDE OF CONNECTIONS VDC POWER SUPPLY REGULATED POWER PER NFPA 70 FOR FIRE PROTECTION WITH BACKUP NEXT CONTROL MODULE OR END OF LINE RELAY RELAY REQUIRED FOR EACH CIRCUIT relay switch contacts are shipped in the standby state open state but may have transferred to the activated closed during shipping To ensure that the switch contacts are in their correct state modules must be made to communi with the panel before connecting circuits controlled by the module Install module wiring in accordance with the job draw and appropriate wiring diagrams Set the address on the module per job drawings Secure module to electrical box supplied by installer shown in Figure 2A When using the IDP Control for fire telephone applications remove Jumper J1 and The Jumper is located on the back under the label as shown in Figure 1B Meridian Circle Grove MN 55369 4927 800 328 0103 763 493 6475 2006 Silent Knight