Silent Knight SK-Minimon Addressable Mini-Monitor Module Manual
File Preview
Click below to download for free
Click below to download for free
File Data
Name | silent-knight-sk-minimon-addressable-mini-monitor-module-manual-0732681954.pdf |
---|---|
Type | |
Size | 766.09 KB |
Downloads |
Text Preview
INSTALLATION AND MAINTENANCE INSTRUCTIONS Clintonville Road Northford CT 06472 Fax 203.484.7118 Monitor Module Operating Voltage Operating Current Resistance SLC Wiring Resistance IDC Wiring Resistance IDC Voltage IDC Current Range length VDC Maximum group poll 350 direct poll 600 Maximum Communicating IDC Shorted Ohms Ohms Ohms Volts to 120 0 to 49 to 93 Non condensing H x 2.75 W x 0.5 D minimum INSTALLINg information is included as a quick reference installation guide Refer to control panel installation manual for detailed system information If the will be installed in an existing operational system inform the opera and local authority that the system will be temporarily out of service Dis power to the control panel before installing the modules This manual should be left with the owner user of this equipment DESCRIpTION SK Minimon monitor module can be installed in a single gang junction directly behind the monitored unit Its small size and light weight allow it be installed without rigid mounting see Figure 1 The SK Minimon is in for use in intelligent two wire systems where the individual address of module is selected using rotary switches It provides a Class B initiating circuit for normally open contact fire alarm and security devices REqUIREMENTS ensure proper operation this module shall be connected to a compatible Knight system control panel list available from Silent Knight 1 AND WIRINg This module is intended to be wired and mounted without rigid con inside a standard electrical box All wiring must conform to appli local codes ordinances and regulations Connect the red and black wires to the positive and negative power leads of the signaling line circuit SLC Connect the violet and yellow wires to a two wire normally initiating loop the specified EOL resistor value to terminate the initiating loop the address on the module per job drawings the module in the desired mounting location 2 TypICAL CLASS B STyLE B INITIATINg DEvICE CONfIgURATION LISTED LINE CIRCUIT SLC WIRING IS AND LIMITED 1 EOL Honeywell International Inc