Silent Knight SKE-V70 Module Installation Instructions

SILENT Honeywell Module Installation SKE V70 converts the speaker circuit from 25 Vrms to 70.7 Vrms The describe how to install and wire the these steps to install the SKE V70 into the main control panel cabinet Unlock and open the cabinet door Remove the two cover plate retaining then open the control panel cover See Figure 1 Splitter Plate Panel Plate Screws Panel Plate Screw 1 View of Cabinet With Cover Plate in Place The control panel cover plate can be remove by removing Run all wire needed to install the system at Mount the module into the cabinet as shown Hinge screw time Figure 2 2 Main Control Board Mounting Location Connect wiring as described in Section Connections SKE V70 supplies one NAC Notification Circuit for speaker connection The circuit can be supervised and wired B Style Y or Class A Style Z The circuit is capable of 50 watts of power Vrms using the SKE V70 Module When the SKE V70 Module is installed all speaker must be separated by a minimum of 1 4 from the voltage wiring and must exit the cabinet through its opening 151305 Module Installation Instructions the SKE V70 to the Control Panel the SKE V70 to the main control panel the supplied wire harness See Figure 3 Speaker outputs of the SKE 450 must not be used with the because supervision will not be provided at the k EOL Listed 7630 Limited 3 Wire Harness Connection From the Main to the SKE V70 the SKE V70 to the or ZN6 the optional SKE ZN4 or ZN6 zone splitter is in the system connect the wire harnesses as below Speaker outputs of the SKE 450 and SKE V70 must not used when using either the SKE ZN4 or SKE ZN6 in with the SKE V70 because supervision will be provided at the SKE 450 and the SKE V70 Connect one harness from the main control the SKE V70 connector marked See Figure 3 Connect the other harness from the SKE connector marked SPLITTER to connector on the SKE ZN4 or ZN6 as in Figure 3 B Style Y 4 illustrates how to wire speakers to the using Class B Style Y supervision 4 Class B Style Y Speaker Configuration A Style Z 5 illustrates how to wire speakers to the using Class A Style Z wiring Limited 5 Class A Style Z Speaker Configuration Specifications Fault Impedance To Any Terminal 0 Input Power 27.4 VDC 10 mA Input Power 27.4 VDC 70 mA Honeywell Meridian Circle Grove MN 55369 4927 or 800 328 0103 763 493 6475 2005 Silent Knight PN 151305 Rev B