Simplex Smoke Detector Tester Operating Instructions

SSimpbc Detector Tester Instructions Simplex Smoke Detector Tester uses an aerosol smoke spray not supplied to test smoke detectors To test a detector follow Steps 1 through 10 below You must use an extender pole not supplied when testing ceiling wall mounted detectors see Figure 1 for more information on smoke detector tester parts NO Smoke Detector Tester w o pole Aerosol Smoke Detector Canister Assembly Detector Ratchet Assembly Pins Extender Pole Extender Pole 1 To adjust the angle of the tester remove lock pin from the base of the tester Adjust the unit to the proper You must not spray the aerosol smoke directly into the smoke detector You must use the tester unit to and reinsert lock pin smoke detectors Turn the top of the canister assembly counterclockwise until it is released from the ratchet assembly Remove cap from aerosol smoke spray can Center can on the ratchet assembly base The smoke detector tester uses a pressurized aerosol smoke spray Do not use or store near spark or open flame Observe all CAUTlON statements on can label Do not store tester unit with can installed Line up threads on the canister with those of the ratchet assembly and turn clockwise until unit is secure Determine the approximate height of the detector to be tested Attach appropriate extender pole To extend the tester pole press in and hold the red button on the pole Extend the pole to the correct height and release button to lock into place Carefully place containment bowl over smoke detector 1995 Simplex Time Recorder Co Gardner MA 01441 0001 specifications other were current as of publication are subject change without notice 701 574 689 3 95 Push up on pole for a maximum of three seconds to release spray into the bowl Adjust allen setscrew down spray does not release see Figure 2 SETSCREW PLATE 2 Pull back on pole to stop spray while keeping bowl in place over detector for a maximum of 20 seconds If does not respond detector has failed the test If detector LED lights remove bowl from the detector Before going to Step 10 see FSB 458R to complete the appropriate test procedure After testing is complete remove can from tester and wipe down the inside of containment bowl using a lint cloth Box 4098 9809 Surface Box is intended the 4098 9809 ceiling mounting Use the Installation Notes and illustration below to Notes See illustration installing a sensor base Installed sensor base is a 4098 9781 or 9783 only Refer to Simplex Publication PER 21 015 574 663 Using the 4098 9809 Surface Box as a template a position appropriate anchoring per local building Use the 4098 9701 Sensor only See WARNING below Refer to Simplex Publication PER 21 023 564 672 when installing 4098 9806 Sensor Guard 10.16 x 1 1 3.81 cm DEEP SUPPLIED NOTE NOTE 2j DEEP x 1 l 2 I surr eD NOTE NOTE WITH NOTE NOTE 3 WITH 3 NFTE NOTE 2 NOTE 3 NOTE NOTE 4 SENSOR GUARD NOTE 4 4 SUPPLIED NOTE 4 USE ONLY A 4098 9701 SENSOR A RESTRICTED SENSITIVITY OF 0.5 TO 1 O PER FT REFER TO 2120 CONFIGURATION REPORT OR CONTROL EQUATION PROGRAMMER 4020 OR 4100 TO SENSITIVITY RANGE