Solidyne M2-R4 Data Sheet

M2 R4 4 Relay Output Module Document 2 11 2004 1 2 3 4 View View Switch LED Plug In the module into female mating stability off power to the or M2V before this module Mating on Plug In Relay Module M2 Plug In Relay Module is a add in relay card that the M2 controller family 4 relay outputs These are designated as outputs 1 through 4 or outputs through 8 and are double pole double throw DPDT can be used as normally open NO or normally NC The module also has HOA switching on each of the four relays as well as a status When the HOA switch is in HAND mode the LED will have a long ON blink and a very short blink If the HOA switch is in OFF mode the LED have a long OFF blink and a short ON blink In Auto the LED will stay ON or OFF depending on the status The M2 R4 module can be used on both the M2 and M2V The terminal block on this module has labeled terminals 26 37 and 48 For example the first relay of the M2 R4 can be output 1 or 5 depending on where the module is inserted the module is inserted into the Relay Module Port on the M2V will designate Relay 1 as the controller Output 5 Then with a marker the 1 of the 15 label can be blacked out to only show 5 Continue this process for outputs 6 7 and 8 so that the relay shows the correct output labels On an M2 two M2 R4 can be used simultaneously to provide outputs 1 through 8 the first M2 R4 module with a black marker mark out the 5 6 7 and 8 and for the second M2 R4 module mark out numbers 1 2 3 and 4 LED Specifications Ratings 5A at 24VAC NO 3A at 24VAC NC Load 10mA at 6VAC Duty Cycle 20 cycles per minute Contact Life 500,000 at 5A NO 200,000 at 3A NC Consumption 8.5VA all relays energized should not be used to switch more than 24VAC Environment 40 to 140 F 4 to 60 C 10 90 Relative noncondensing Storage Temperature 10 to 150 F 23 to 66 C Storage Humidity 0 95 Relative noncondensing REV 2 11 2004 Corporation 4215 Kirchoff Rd Rolling Meadows IL 60008 800 648 3980 www solidyne com