System Sensor DH100ACDCI Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Ionization Duct Smoke Detector Installing for Proper Use Smoke Detectors in Duct Applications A05 1004 which detailed information on detector spacing placement available online at www systemsensor com or via System toll free fax back service Documents on Demand at This manual shall be left with the owner user of This detector must be tested and maintained reg following NFPA 72 requirements The detector should be of Contents 1 1 1 2 2 4 5 5 8 8 General Description to the entire building Smoke detectors designed for DH100ACDCI Air Duct Smoke Detectors utilizes ioniza air passing through the duct and allows detection of a de flashes to indicate power a red LED signals local alarm the reset button on the front cover the control panel or DH100ACDCI incorporates a cover feature that provides a trouble signal after 7 minutes if cover is removed or improperly installed Limitations Of Duct Smoke Detectors National Fire Protection Association has established that Sensor supports this position and strongly recom Contents Of The Duct Smoke Detector Kit Complete Two Two One Drilling Two One One One For ducts over 11 feet longer sampling tubes must be to complete the installation They must be the correct Figure 1 Exploded View Of Duct Smoke Detector Components Installation Sequence Verify Duct Air Flow Direction And Velocity Drill The Mounting Holes Sampling Tube Installation for Ducts Less 11 Feet Wide see Figure 2 Remove Slide 1 2 Plastic sampling tube to duct smoke detector Secure The Detector Housing To The Duct 3 Do not overtighten the screws 3 Installation of foam gaskets over sampling bushings Sampling Tube Installation for Ducts Greater 11 Feet Wide other lengths must be purchased separately Order the cor