System Sensor M500CH Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Monitor Module and Control Module Installing information is included as a quick reference installation Refer to the control panel installation manual for detailed information If the modules will be installed in an existing system inform the operator and local authority that system will be temporarily out of service Disconnect power the control panel before installing the modules This manual should be left with the owner user of this Description Monitor Modules provide a two wire or fault tolerant circuit for normally open contact fire alarm and supervi devices or either normally open or normally closed security The LED indicator can be latched on or returned to the mode by code command from the panel Convenient rota decade switches are used to set the address of each module Control Modules allow a compatible control panel to discrete contacts by code command The control module a status LED that can be latched on or returned to the normal by code command from the panel Rotary decade switches used to set the address of each module control module offers two modes of switching operation shipped the module is configured for switching an external source to notification appliances The external power can be a DC power supply or an audio amplifier up to Vrms In this mode the module reports supervision status the connected loads to the control panel Load circuit status is as a NORMAL OPEN or SHORTED circuit Two pairs of termination points are available for fault tolerant wiring second mode of switching operation allows the panel to con one Form C SPDT set of contacts Circuit connections to the are not supervised by the module This mode is enabled breaking two external tabs on the module Requirements insure proper operation these modules shall be connected to compatible system control panels only M500M and M500CH Devices and M500CH modules mount directly to 4 square electri boxes as shown in Figure 2A The box must have a minimum of 21 All wiring must conform to applicable local codes ordi and regulations When using control modules in limited applications the System Sensor CB500 Barrier must be used to meet UL requirements the separation of power limited and nonpower lim terminals and wiring The barrier must be inserted a 4 junction box and the control module Division of Pittway 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 be placed into the barrier and attached to the junc box Figure 2A The power limited wiring must be into the isolated quadrant of the module barrier 2B Install module wiring in accordance with the job drawings and wiring diagrams Figures 3 9 Set the address on the module per job drawings Secure module to electrical box supplied by installer as in Figure 2A Test monitor and control modules can be tested with a test mag available from System Sensor M02 04 01 see Figure 1 The test checks the module electronics and connections to the panel Interfaced initiating and indicating devices must be independently 1 Monitor and control module controls and indicators 2A Module mounting with barrier 2B 1 I56 314 14 Monitor Module Wiring Diagrams 3 Typical 2 wire initiating circuit configuration NFPA Style A or B