System Sensor PS12 24SLENSW and PS12 24SLENSC Manual
File Preview
Click below to download for free
Click below to download for free
File Data
Name | system-sensor-ps12-24slensw-and-ps12-24slensc-manual-4735016298.pdf |
---|---|
Type | |
Size | 694.43 KB |
Downloads |
Text Preview
INSTALLATION AND MAINTENANCE INSTRUCTIONS Strobe Lens This manual should be left with the owner user this equipment 1 SMOKE lens 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 Information National Fire Protection Association has published standards and recommended practices for the and use of this product It is recommended that installer be familiar with these requirements with local and any special requirements of the local authority jurisdiction SMOKE strobe lens is designed to replace the FIRE used with the PS12 and PS24 strobes To install the SMOKE lens a PS12 or PS24 strobe must be purchased separately the two screws on the back of the PS12 or PS24 see Figure 2 The FIRE lens can now be removed this procedure to install the SMOKE lens follow the installation instructions I56 305 07 with the PS12 and PS24 accessory to complete installation Numbers lens wall mount lens ceiling mount 2 Remove the rear screws Leg Limited Warranty Sensor warrants its enclosed SMOKE lens to be free from defects materials and workmanship under normal use and service for a period three years from date of manufacture System Sensor makes no other warranty for this SMOKE lens No agent representative dealer employee of the Company has the authority to increase or alter the or limitations of this Warranty The Company obligation of Warranty shall be limited to the repair or replacement of any part of SMOKE lens which is found to be defective in materials or workman under normal use and service during the three year period com with the date of manufacture After phoning System Sensor free number 800 SENSOR2 736 7672 for a Return Authorization send defective units postage prepaid to System Sensor Returns RA 3825 Ohio Avenue St Charles IL 60174 include a note describing the malfunction and suspected cause failure The Company shall not be obligated to repair or replace units are found to be defective because of damage unreasonable use or alterations occurring after the date of manufacture In case shall the Company be liable for any consequential or incidental for breach of this or any other Warranty expressed or implied even if the loss or damage is caused by the Company neg or fault Some states do not allow the exclusion or limitation of or consequential damages so the above limitation or exclusion not apply to you This Warranty gives you specific legal rights and may also have other rights which vary from state to state 2002 System Sensor