System Sensor RA100Z Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS and RA100ZA Canadian Annunciator Range System System Alarm Current Range to 32 VDC Installation of jumper required Note 1 to 32 VDC Do not install jumper mA maximum to 60 14 to 140 FM CE 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 jumper when using an RA100Z or RA100ZA with any conventional duct detector such as the System Sensor model D2 or D4120 1 RA100Z and RA100ZA replaces RA400Z and RA400ZA INFORMATION National Fire Protection Association has published codes standards and practices for the installation and use of the above appliance It recommended that the installer be familiar with these requirements with codes and any special requirements of the local authority having juris models RA100Z RA100ZA remote annunciators are polarized devices for both conventional and intelligent applications They have been using an active current regulator so that the maximum current re from the system is 10mA when the input voltage is within the specified range remote annunciator is intended to be mounted to a single gang electrical box The wiring must be in compliance with all codes The device must operated within its published specifications the remote annunciator according to the instructions supplied with the being monitored Polarity of the incoming wires must be observed and to the proper terminals and See Figure 2 provided jumper must be installed for use with System Sensor Conventional To install jumper slide jumper over both pins see Figure 3 Note 1 2 3 JUMPER FOR CONVENTIONAL SYSTEM LIMITATIONS OF REMOTE ANNUNCIATORS REMOTE ANNUNCIATOR WILL NOT WORK IF THE DEVICE IT IS CONNECTED IS NOT POWERED The remote annunciator gets its power from the device to which is connected If for any reason the device being monitored loses power the remote will not provide the intended visible signal REMOTE ANNUNCIATOR MAY NOT BE SEEN The model RA100Z is suitable for viewing and is in compliance with existing Underwriters Laboratories standards device must be sited in a location where it can be seen by the intended parties The must not be installed in direct sunlight or areas of high light intensity where the signal might be disregarded or not seen DEVICE IS DESIGNED TO WORK SPECIFICALLY WITH SYSTEM SENSOR Interconnection with devices other than System Sensor may result in un operation Consult device manufacturer for compatibility REMOTE ANNUNCIATOR IS NOT INTENDED TO BE A VISIBLE WARNING SIGNAL LIMITED WARRANTY Sensor warrants its enclosed smoke detector base to be free from defects in ma and workmanship under normal use and service for a period of three years from of manufacture System Sensor makes no other express warranty for this smoke base No agent representative dealer or employee of the Company has the au to increase or alter the obligations or limitations of this Warranty The Company of this Warranty shall be limited to the repair or replacement of any part of smoke detector base which is found to be defective in materials or workmanship normal use and service during the three year period commencing with the date of After phoning System Sensor toll free number 800 SENSOR2 736 7672 a Return Authorization number send defective units postage prepaid to Honeywell Rojas Drive Suite 700 El Paso TX 79936 USA Please include a note describing the and suspected cause of failure The Company shall not be obligated to repair replace units which are found to be defective because of damage unreasonable use or alterations occurring after the date of manufacture In no case shall the be liable for any consequential or incidental damages for breach of this or any Warranty expressed or implied whatsoever even if the loss or damage is caused by Company negligence or fault Some states do not allow the exclusion or limitation of or consequential damages so the above limitation or exclusion may not apply you This Warranty gives you specific legal rights and you may also have other rights vary from state to state System Sensor 06 10