System Sensor Strobe EngSpec

Architects and Engineering Specification Advance Strobe strobe appliance shall be System Sensor model number The strobe shall mount to a 4 4 1 back box 4 inch octagon back box double gang back box or a single gang 2 17 back box A universal mounting plate shall be used for mounting ceiling and wall products notification appliance circuit wiring shall terminate at the universal mounting plate strobe and the Sync Module MDL3 accessory if used shall be powered from a non coded appliance circuit output and shall operate on a nominal 12 or 24 volts includes fire alarm with built in sync When used with the Sync Module MDL3 12 volt rated notification circuit outputs shall operate between 8.5 and 17.5 volts 24 volt rated notification appliance outputs shall operate between 16.5 to 33 volts If the notification appliances are not UL 9th edition with the corresponding panel or power supply being used then refer to the compatibility listing of the to determine maximum devices on a circuit strobe shall have field selectable candela settings including 15 15 75 30 75 95 110 115 135 150 185 Shall be listed to UL 1971 and shall be approved for fire protective service The strobe shall be as a primary signaling notification appliance and comply with the Americans with Disabilities Act for visible signaling appliances flashing at 1Hz over the strobe entire operating voltage The strobe light shall consist of a xenon flash tube and associated lens reflector system The shall operate between 32 and 120 shall be plug in and shall have the ability to check wiring continuity via a shorting spring on the mounting plate The shorting spring shall also provide tamper resistance via an open circuit if the is removed notification appliances shall be backward compatible