Wheelock EN4 enclosure install sheet P83937

Branchport Avenue Branch NJ 07740 631 2148 Thank you for using our products INSTRUCTIONS STROBE APPLIANCE ENCLOSURE this product according to this instruction manual Please keep this instruction manual for future reference Strobe Appliance Enclosure Model EN4 is designed to be used with Wheelock Series RSS Strobe Appliance The enclosure rated as a NEMA 4 enclosure provides protection from windblown dust rain and snow The EN4 enclosure is UL for use both indoors or outdoors in areas with a temperature range from 0 C 32 F to 49 C 120 F See Table 1 below for listed candela cd ratings of the RSS Strobe when using the EN4 Enclosure All CAUTIONS and WARNINGS are identified by the symbol All warnings are printed in bold capital letters PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT FAILURE COMPLY WITH ANY OF THE FOLLOWING INSTRUCTIONS CAUTIONS AND WARNINGS COULD RESULT IN APPLICATION INSTALLATION AND OR OPERATION OF THESE PRODUCTS IN AN EMERGENCY WHICH COULD RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY OR DEATH TO YOU OTHERS DO NOT USE THE EN4 ENCLOSURE IN INSTALLATIONS WHERE TEMPERATURES MAY FALL OF THE UL LISTED TEMPERATURE RANGE TEMPERATURE 0 C 32 F TO 49 C 120 F AS DAMAGE TO FAILURE OF NOTIFICATION APPLIANCE MAY RESULT DO NOT SET THE MULTI CANDELA STROBE APPLIANCE ON THE 15cd SELECTION THE LIGHT OUTPUT RATING FOR THE 15cd SELECTION WILL NOT MEET THE MINIMUM OF NFPA 72 USE SETTINGS OF 30cd OR HIGHER 1 UL Candela Ratings for Series RSS Strobe when using EN4 Enclosure Candela Series No 75cd 95cd No EN4 to Series RSS P83500 and P83501 RSS Multi Candela Wall P83911 and RSS Multi Candela Ceiling P84394 Installation for additional information 2003 2004 Wheelock Inc All rights reserved E 1 of 3 INFORMATION ENCLOSURE HEIGHT 80 VIEW OF ENCLOSURE THE 4 EXTERNAL MOUNTING INTO ENCLOSURE SLOTS AS USING ENCLOSURE ASSEMBLY TEMPLATE PLACE AGAINST MOUNTING WITH CENTERLINE 80 INCHES FLOOR MARK AND DRILL 4 HOLES DIA X 1 DEEP 12 X 1 MOUNTING TABS 10 X 1 1 2 RETAINING CLIPS 8 32 X 3 8 SOCKET SCREWS AFTER ALL INSTALLATION PROCEDURES HAVE BEEN COMPLETED INSTALL GASKET IN ENCLOSURE GROOVE NOW COVER IN GROOVE AND POSITION THE FOUR 4 CLIPS IN THE SLOT CLOSEST TO EDGE OF COVER IN SQUARE FLUSH BACKBOX MOUNTING INSTRUCTIONS INSTALATION FOR AREAS WITH WASHDOWNS OFF BLOCKS 4 ENTRY HOLE BE FIELD DRILLED DRILL A PILOT HOLE MAXIMUM 1 2 COMPLETE DIA USING A 1 1 16 DRILL BIT OR HOLE SAW VIEW MOUNTING 4 INSTRUCTIONS FOR AND COVER Rinse with water to remove abrasive dust Wash with soap or mild detergent using a cloth do not scrub Rinse once more than dry with a soft cloth Rinse with water to remove abrasive dust Wash with soap or mild detergent using a dirt chamois dirt chamois Rinse once more than dry with a soft cloth remove grease or wet paint rub gently with a wetted thoroughly with naptha then wash rinse DO NOT USE RAZOR BLADES E 2 of 3 Figure A is typical of a in Rain tight conduit hub with neoprene o ring threaded for rigid cloth do not scrub and imc O Z GEDNEY CHM 75 or equivalent Figure B is typical of a in female adapter Carlton E942 or equivalent Figure C is typical of a in 1 2 in reduce bushing Appleton RB series or equivalent Figure D is typical of a galvanized in conduit nipple Figure E is typical of a in conduit lock nut Figure F is typical of a 4 in X 2 in Deep Square Backbox 9RACO190 or equivalent FAILURE TO FOLLOW THE INSTALLATION INSTRUCTIONS OR TO SUBSTITUTE ELECTRICAL RIGID FITTINGS THAT DO NO COMPLY WITH CURRENT PRACTICES ADAPTED BY NEC NFPA AND ANSI CODES RESULT IN LOSS OF PROTECTION FROM WATER OR DUST IN ALL AREAS WHERE FREQUENT WASH DOWNS OCCUR STAND OFF BLOCK MUST BE INSTALLED MATERIAL EXTRAPOLATED FROM THIS DOCUMENT OR FROM WHEELOCK MANUALS OR OTHER DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS OR FOR ANY USE INCLUDING DESCRIPTION OF THE PRODUCT APPLICATION OPERATION INSTALLATION AND IS USED AT THE SOLE RISK OF THE USER AND WHEELOCK WILL NOT HAVE ANY LIABILITY FOR SUCH Warranty products must be used within their published specifications and must be PROPERLY specified applied installed operated and operationally tested in accordance with these instructions at the time of installation and at least twice a year or more and in accordance with local state and federal codes regulations and laws Specification application installation operation and testing must be performed by qualified personnel for proper operation in accordance with all of the latest National Protection Association NFPA Underwriters Laboratories UL Underwriters Laboratories of Canada ULC National Code NEC Occupational Safety and Health Administration OSHA local state county province district federal and applicable building and fire standards guidelines regulations laws and codes including but not limited to all appendices and and the requirements of the local authority having jurisdiction AHJ Wheelock products when properly specified installed operated maintained and operationally tested as provided above are warranted against mechanical and electrical for a period of three years from date of manufacture as determined by date code Correction of defects by repair or shall be at Wheelock sole discretion and shall constitute fulfillment of all obligations under this warranty THE LIMITED WARRANTY SHALL IMMEDIATELY TERMINATE IN THE EVENT ANY PART NOT FURNISHED BY IS INSTALLED IN THE PRODUCT THE FOREGOING LIMITED WARRANTY SPECIFICALLY EXCLUDES ANY REQUIRED FOR THE OPERATION OF OR INCLUDED IN A PRODUCT WHEELOCK MAKES NO OR WARRANTY OF ANY OTHER KIND EXPRESS IMPLIED OR STATUTORY WHETHER AS TO FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER MATTER ARE SOLELY RESPONSIBLE FOR DETERMINING WHETHER A PRODUCT IS SUITABLE FOR THE USER PURPOSES WHETHER IT WILL ACHIEVE THE USER INTENDED RESULTS THERE IS NO WARRANTY AGAINST DAMAGE FROM MISAPPLICATION SPECIFICATION ABUSE ACCIDENT OR OTHER OPERATING BEYOND WHEELOCK CONTROL WHEELOCK PRODUCTS CONTAIN SOFTWARE WITH RESPECT TO THOSE PRODUCTS WHEELOCK DOES NOT THAT THE OPERATION OF THE SOFTWARE WILL BE UNINTERRUPTED OR ERROR FREE OR THAT THE WILL MEET ANY OTHER STANDARD OF PERFORMANCE OR THAT THE FUNCTIONS OR PERFORMANCE OF SOFTWARE WILL MEET THE USER REQUIREMENTS WHEELOCK SHALL NOT BE LIABLE FOR ANY DELAYS INTERRUPTIONS LOSS DESTRUCTION ALTERATION OR OTHER PROBLEMS IN THE USE OF A PRODUCT OUT OF OR CAUSED BY THE SOFTWARE LIABILITY OF WHEELOCK ARISING OUT OF THE SUPPLYING OF A PRODUCT OR ITS USE WHETHER ON NEGLIGENCE OR OTHERWISE SHALL NOT IN ANY CASE EXCEED THE COST OF CORRECTING DEFECTS STATED IN THE LIMITED WARRANTY AND UPON EXPIRATION OF THE WARRANTY PERIOD ALL SUCH LIABILITY TERMINATE WHEELOCK IS NOT LIABLE FOR LABOR COSTS INCURRED IN REMOVAL REINSTALLATION OR OF THE PRODUCT BY ANYONE OTHER THAN WHEELOCK OR FOR DAMAGE OF ANY TYPE WHATSOEVER BUT NOT LIMITED TO LOSS OF PROFIT OR INCIDENTAL OR CONSEQUENTIAL DAMAGES THE FOREGOING CONSTITUTE THE SOLE REMEDY OF THE PURCHASER AND THE EXCLUSIVE LIABILITY OF WHEELOCK NO CASE WILL WHEELOCK LIABILITY EXCEED THE PURCHASE PRICE PAID FOR A PRODUCT of Liability LIABILITY ON ANY CLAIM OF ANY KIND INCLUDING NEGLIGENCE AND BREACH OF WARRANTY